Streetscape Mailbox Installation Instructions

Each post mount mailbox has four holes positioned to match the mounting holes on every Streetscape mailbox pole support plate.

The holes are centered on the bottom of the box 5 1/2" front to back and 5 1/4" side to side.

Four 3/4" stainless machine screws with nuts and washers are provided with each mailbox.

1) Set mailbox in place aligning mailbox holes to holes in support plate.
2) Insert screws in large washers through mailbox holes from the inside.
3) Secure split lock washers and nuts to screws from under the support plate.
4) Tighten using a 5/32" Allen wrench inside mailbox, and pliers to hold nut.

If mounted to a 4" X 4" wood post with 1 1/2" to 2" cross boards (very common) the holes should align near the center of the cross boards.

Four 1 1/4" X 1/4" stainless hex head lag bolts with large washers are suggested (mark and pre drill holes to avoid splitting wood).

NOTE: Installation for the Oxford mailbox is the same except the hole pattern and is 8 1/2" front to back and 7 1/4" side to side. It is designed for use with the Newport Large Mailbox Post.